What safety precautions should be taken when operating Hydraulic Cylinder Machine tools

Hydraulic Cylinder Machine tools are commonly used in metal processing, but improper operation may cause danger. The following are key safety specifications:

Pre-start inspection

Confirm that the hydraulic oil is sufficient and there is no leakage

Check whether the circuit and oil circuit connections are normal

Make sure that all fasteners are not loose

Personal protection

Wear work clothes, safety helmets and protective glasses

Do not wear gloves to operate rotating parts

Long hair should be tied up to avoid being caught in the machine

Operation specifications

First run at no load for 1-2 minutes and observe whether the pressure gauge is normal

The workpiece must be clamped to prevent splashing

Do not overload and pay attention to the rated pressure range

Emergency treatment

Stop immediately when there is a sudden abnormal sound or oil pipe burst

Cut off the main power after pressing the emergency stop button

Rinse with clean water for 15 minutes when hydraulic oil splashes on the skin

Stop maintenance

Depressurize to zero after work

Use special tools to clean iron filings

Replace the filter regularly to keep the oil clean

Compliance with these requirements can effectively prevent work-related injuries and equipment damage. New employees need to pass training before they can operate Hydraulic Cylinder Machine tools independently.